The
incoming dry bottle (sterilized and
siliconised) are fed through the infeed
Turn Table with suitably guided on
the moving delrin flat conveyor belt
at the required speed for feeding.
There are two separate filling head
mounted on machine top plate in the
same line. When bottle reaches to
the first filling station, it will
be held by the pneumatic bottle holder.
Immediately it will be sensed by the
bottle sensor as soon as it gets signals
from sensor magnetic clutch starts
to rotate which is mounted on auger
shaft. It will fill the desired amount
of powder to the bottle through auger,
where rotation time is previously
saved in PLC control. After filling
of first bottle pneumatic piston goes
back and release the first bottle
to move on conveyor, By the same time
second bottle also moves along with
the first bottle in empty condition.
In second filling head same operation
will be performed but this time second
bottle get filled and first bottle
moves further for next operation.
The main advantage of this machine
is Pneumatic bottle holding system
is directly connected with Auger rotation,
so till bottle get filled with powder
as per set value pneumatic system
will not going to release the bottle. |
